Faber Cristalfab Plus is a ready to use water based product for the crystallization of carbonate materials, such as Marble and Limestone. This quick and easy to use product is suitable for the periodic maintenance of surfaces undergoing high traffic, therefore loosing part of their initial sheen easily. This product is also great for the final polishing of surfaces after the traditional honing process. This product is a low acidity crystallizer that does not produce slipperiness or an orange peel look, as other products may, nor does it turn marbles yellow or grey. Compared to the original Cristal Fab, this PLUS version produces higher brightness, especially concerning gloss degrees.
Directions for use:
- Faber Cristalfab Plus must be used undiluted.
- Ensure all surfaces are clean, free of loose dirt and debris, and are completely dry before application.
- Work on small surface portions of around 2sqm at a time.
- Before application, it is recommended that the product is poured into a bottle with a wide sprayer.
Spray product on to the area to crystallize and work immediately after spraying until the product will be dry (spray buffing) with a monobrush (150/200rpm) and steel wool pad for crystallizations. Brush the area until completely dry with concentric movements all over the area, continuing even after drying, until the desired sheen level has been achieved. At the end of this process,remobe all residues of fine steel-wool remaining on the surface with a dry cloth. For particularly worn out surfaces undergoing high traffic, repeat crystallization process up to three times, depending on the expected result.
This product with cover roughly 30/40 sqm for polishing, or 40-50 sqm for maintenance.
Safety Data sheet for this product is available here. View our other Faber products here.